Sticky : The CZ / Bolt action rimfire picture thread !

[eco]

Need to add a nice bipod. Any suggestions?
It's 9.4lbs as is. Bit of a workout. Haven't tried yet, nor adjusted the scope.
Looked at the mdt acc but that one was over 10lbs without the scope!

 

[Meroh]

Using an Oryx on the old 452/455 action is a genius move. The chassis is so flat that you need to run high scope rings no matter what, rendering the 90° bolt throw a total non-issue for optic choice.

Thanks; less expensive action, same barrel selection. Unfortunately, the oryx is not made (I asked) for the 452, and the 455 does not fit the 457 Chassis. I love my very early 452, I still consider these to be CZs Apex .22.

 

[Canadiankeeper]

CZ 457 in 17HMR heavy barrel. Are 419 pic rail and bolt knob, Vortex Diamondback Tactical topped with a DNT Zulus for video recording. Excellent gopher gun!

synthetic stock painted?

 

[olefrt63]

synthetic stock painted?

Factory synthetic stock from CZ. It came with a 22LR stainless barrel, and I just did the 17HMR varmint barrel swap.

 

[Every Shot Counts]

Just set-up a CZ 457 MTR for a friend where this will be his first gun ever and first time out at the range.
The exact same rifle and accessories as mine except with a different scope.

I installed the scope twice (the first scope was defective) and sighted it in the other day. I also cut out the Plano case foam for him.



And it shot pretty well after getting it sighted-in...5 shots...