taping up your muzzle while hunting?

Great, more fruck'in chit and debris out in the bush along with cigarette skins, packages,
sammich bags, cawfie cups, timminie bawxes and now shieks.
 
Great, more fruck'in chit and debris out in the bush along with cigarette skins, packages,
sammich bags, cawfie cups, timminie bawxes and now shieks.

LOL. I have been using electrical tape on the muzzle since himself was a cowboy. It's still there after a shot is fired, it just looks different. :) No litter on the forest floor...
 
I saw in magazine where they did study on this. Electrical tape made no effect on accuracy or POI. Water in the barrel (simulated by sticking a few inches into a bucket then shaking it out) made quite an unwanted change to accuracy and POI
 
i have used a finger off a nitrile glove a few times but mostly electrical tape. i tape the muzzle then put a couple of wraps of tape a couple of inches down the barrel in case i need to redo the tape on the muzzle.
 
i have used a finger off a nitrile glove a few times but mostly electrical tape. i tape the muzzle then put a couple of wraps of tape a couple of inches down the barrel in case i need to redo the tape on the muzzle.
Same drill here, works well
 
I saw in magazine where they did study on this. Electrical tape made no effect on accuracy or POI. Water in the barrel (simulated by sticking a few inches into a bucket then shaking it out) made quite an unwanted change to accuracy and POI

Here is the article written by a gentleman from Sierra bullets.
sierrabulletsblog.com/2015/07/22/how-on-earth-did-i-miss-that-shot/amp/
 
Here is the article written by a gentleman from Sierra bullets.
sierrabulletsblog.com/2015/07/22/how-on-earth-did-i-miss-that-shot/amp/

Interesting article. Curious though, how a 47fps DROP in muzzle velocity can contribute to shooting HIGH...

How On Earth Did I Miss That Shot?

Sierra Bullets
3 years ago
Written by Sierra Bullets Chief Ballistician Tommy Todd

Over the years I have been on a hunting trip or possibly even just out shooting and enjoying the outdoors with a fine rifle, and have experienced a flat-out miss when shooting at either a target of opportunity or an animal. Of course, the first thing that crosses my mind is “How on Earth did I miss that shot!?!”

I’m notorious for saying after an unbelievable miss “I’d sell you that sight picture!” By which I mean that the crosshairs of the scope or the appearance of the sights were such that I would take the same shot again and again and expect perfect bullet impact and yet the dreaded MISS occurred.

An example of this scenario occurred a few years ago while my wife and I were antelope hunting in the great state of Wyoming. We have some friends that have a ranch up in the mountains and they allow us the privilege of hunting with them occasionally. This particular trip we had a foot of snowfall overnight. They were really excited as they seldom get the chance to hunt antelope in the snow and we were really excited as we seldom get to hunt antelope period.

We spotted a small herd of “goats” and executed a stalk on them and despite having to crawl for about a hundred yards, we got into a shooting position up on a knoll about 150 yards from the herd. I had a doe/fawn tag and after quietly watching the herd for awhile and a whispered discussion as to hopefully picking a doe out that did not have yearlings hanging with her still. A particular antelope was picked out and while the other three peeked over the sagebrush I steadied the gun for a shot on some shooting sticks. I was shooting a recently built 358 Winchester and was shooting Sierra’s 225 gr. Spitzer boattail bullets (#2850).

At the crack of the rifle the last thing I saw in the scope was perfect crosshair alignment and the rifle tracking straight back towards me. I expected excitement and high fives after the shot, instead my buddy said “I can’t believe you missed that doe that far!” He watched the bullet hit WAY OVER her back. Now I’m not the best shot in the world, but I KNOW when I shoot a good sight picture and execute follow through. Immediately my mind started churning and the best we could come up with was possibly snow in the barrel. Remember the foot of new snow and the crawl to get into shooting position?

Upon returning to work I thought up a test to verify/or crush the theory that snow/water had gotten into the muzzle of my rifle and caused a wild shot. I did not have anything covering the muzzle and as you know a 35 caliber bore diameter is fairly large and could easily have gotten contaminated.

To test my theory, I loaded nine rounds of 308 Winchester ammunition. I utilized the 165 grain SBT bullet (#2145) and enough Accurate 2495 powder to shoot well (approximately 38 grains).* I then utilized a fouled 308 Winchester barreled action in one of our return-to-battery machine rests for the evaluation. This testing was conducted at 200 yards.

I fired three shots and documented the velocity at 2378 fps. I then fired three more shots but before each shot I placed a piece of electricians tape over the muzzle, this would effectively keep any water out of the barrel if placed properly. There was no accuracy or velocity change with the electricians tape in use as you can see.

DSCN1606
DSCN1611
Dipping_Barrel_in_WaterI had my right hand man in all things bullet related, Tony, dip the muzzle of the test rifle into a bucket of water before each of the next three shots.**

Shooting with the last eight inches or so of bore wet reduced the velocity of this load by 47 fps. As you can see from the target results below, you don’t want any water in your barrel if you intend to hit what you’re aiming at. I believe I found the reason that antelope doe escaped my efforts to transform her into table-fare.

2Spreads
Luckily for me, an hour after missing the first doe, I got another chance and made a very good shot on another antelope at approximately double the distance of the first attempt and the bullet hit precisely as intended. I’m betting that the barrel interior was wet the first time and dry on the second attempt. I have often heard the saying “keep your powder dry,” from my experience and this test, one could add “and your barrel!”

*Please note: While this load was safe in the rifle used in this article, it may not be safe in your specific firearm.

**If you think there might be any obstruction in your barrel, unload your gun and check. Do not fire any firearm with the barrel obstructed in any way.
 
I too run electrical tape on the muzzles no matter the time of year or where I am hunting. I carry a small roll of it in my pocket to retape should it be needed. Never an issue with it affecting POI
 
When I cut the barrel of my .375 H&H to 20" I had my gunsmith re-install the front sight ramp about half an inch to the rear from the crown so that it is easier to tape the muzzle.

9VnQchml.jpg


26QmnkDl.jpg
 
Last edited:
Always tape the muzzle!!! When I was young we were bouncing in and out of the truck on a snowy gross sask day. After getting out of the truck and getting ready to go for a walk and see if I couldn't rattle in a monster sask buck, I had a weird feeling, so before loading my gun I checked the muzzle and about 1/2" of mud found it's way into the barrel. Not sure how, but it did. I grabbed a twig and cleaned it out then continued hunting. But ever since then, every muzzle gets taped and I've never had that happen since.
 
I squeeze aluminum foil around the muzzle..it stays on and is visible enough that you can't miss it before you shoot.

Curious what you mean by that? As in, to double check it’s still on there and hasn’t let any mud in? Or as a reminder to pull it off?
 
Back
Top Bottom