This Stock ?

OP- Cant tell from your pic if there is a recess in the stock where the front of the floor plate and stock bolt meet. The recess would be about 1/4 inch. If you look at some pics (google) of a standard Pattern 14, you can see the original stock and bent floorplate arrgt.
 
cosmic said:
OP- Cant tell from your pic if there is a recess in the stock where the front of the floor plate and stock bolt meet. The recess would be about 1/4 inch. If you look at some pics (google) of a standard Pattern 14, you can see the original stock and bent floorplate arrgt.
Click to expand...
Cosmic Any chance you could post a picture of what you are describing ?
Thanks
 
Do you fellas need better pictures to help identify what action and barrel will fit in this stock nicely . Meaning all the metal would fit into the recesses .
I think I would really like to make it whole .
 
Leavenworth said:
Do you fellas need better pictures to help identify what action and barrel will fit in this stock nicely . Meaning all the metal would fit into the recesses .
I think I would really like to make it whole .
Click to expand...
Measure the action screw spacing
 
With the following pictures I used a micrometer to measure the depth of certain recesses .The bottom of the micrometer has a pin to measure depths of holes etc . So the resulting measurements taken are shown by where the zeros line up on either the
MM scale or the Inch scale . Hope these pictures show what you asked for .

The distance between action screws centre to centre is 7 3/4 inches
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom