Tavor FAQ (updated 08 December, 2008)
- Thread starter b-wingpilot
- Start date
Thoughts?
I just completed the custom 'suppressssor' on it... IMHO it 'balances' the gun quite well compared to a naked pencil barrel.
My next step is to get black IDF grip panels, but I'm not sure if I should get the whole pistol grip component as well instead of just the panels.
Without the 'suppressssor':
(disregard bottom project-rifle
)
I just completed the custom 'suppressssor' on it... IMHO it 'balances' the gun quite well compared to a naked pencil barrel.
My next step is to get black IDF grip panels, but I'm not sure if I should get the whole pistol grip component as well instead of just the panels.
Without the 'suppressssor':
(disregard bottom project-rifle
)
Last edited:
Hi, i got it off another CGN member, it's a non-branded generic can... I think I got it for 35 or 40$... dont remember!
You can pretty much get any reverse-threaded can and cut it to fit. This one was 1.25" too long, and I cut it very flush for the x95
Last edited:
onetwentyish
CGN Ultra frequent flyer
- Location
- East Central AB (AKA Northern Texas)
Thoughts?
I just completed the custom 'suppressssor' on it... IMHO it 'balances' the gun quite well compared to a naked pencil barrel.
My next step is to get black IDF grip panels, but I'm not sure if I should get the whole pistol grip component as well instead of just the panels.
Without the 'suppressssor':
(disregard bottom project-rifle
Gotta admit that is one of the nicest x95 builds I have seen in a while, just looks clean.
That said the optic looks way to low to achieve a comfortable sight picture.
Thoughts?
I just completed the custom 'suppressssor' on it... IMHO it 'balances' the gun quite well compared to a naked pencil barrel.
My next step is to get black IDF grip panels, but I'm not sure if I should get the whole pistol grip component as well instead of just the panels.
Without the 'suppressssor':
(disregard bottom project-rifle
Looks friggin amazing. Do you mind sharing how long the shroud suppressor is after you cut it? I'm trying to find one to do the exact same thing. How did you cut it?
Cheers
Ok guys.. I'm having a problem disassembling my BCG on my new (to me) X95. I'm supposed to pull back the buffer and then the bolt rotation rod, right? Well the buffer will not move. The bolt rotation rod extends out about 1" (compared to the 1cm'ish I've seen in videos.) I've owned a couple Tavors in the past and never had this problem.
20180903_151742 by Brian Speight, on Flickr
20180903_151742 by Brian Speight, on Flickr
N Wansbutter Esq
Member
- Location
- Stratford, Ontario
I'm having the exact same problem. I've never owned a Tavor before, but fired my X95 for the first time over a two day course last week and encountered this when trying to clean it.
Aside from this, awesome rifle, I was very happy with its performance. Put about 700 rounds through it over two days and it was flawless. I ran the factory trigger et al. and thought it was fine so now I am debating whether the Giessel trigger pack is worth the money.
Aside from this, awesome rifle, I was very happy with its performance. Put about 700 rounds through it over two days and it was flawless. I ran the factory trigger et al. and thought it was fine so now I am debating whether the Giessel trigger pack is worth the money.
###
Last edited:
Last edited:
