Robarms XCR FAQ post
- Thread starter SIGGER
- Start date
Hello Y'All,
Has anyone else experienced pitting on the top of the barrel directly below the holes drilled into the gas tube. The gas tube is installed with the holes directed down. The rifle is chamberd in 223 as purchased. I've run mostly american eagle, winchester 50ish grain ammo through it. I'll be the first to admit I'm lazy about cleaning my rifles after coming home from the range. Is this a common-uncommon issue or did I F*ck up by being lazy.
Thanks for the input,
-Tiber
Has anyone else experienced pitting on the top of the barrel directly below the holes drilled into the gas tube. The gas tube is installed with the holes directed down. The rifle is chamberd in 223 as purchased. I've run mostly american eagle, winchester 50ish grain ammo through it. I'll be the first to admit I'm lazy about cleaning my rifles after coming home from the range. Is this a common-uncommon issue or did I F*ck up by being lazy.
Thanks for the input,
-Tiber
blaxsun
CGN Ultra frequent flyer
3:57...
Fellow XCR-L owners,
Cleaned my XCR today to head off to Connaught for the SR Match and...
After approx the 3000rd Mark the gas rod broke, it looked like a stress fracture and eventually it was almost a complete 360
I could not imagine what would have happened if it had broke during firing!
Anyone here experience the same issue?
Cleaned my XCR today to head off to Connaught for the SR Match and...
After approx the 3000rd Mark the gas rod broke, it looked like a stress fracture and eventually it was almost a complete 360
I could not imagine what would have happened if it had broke during firing!
Anyone here experience the same issue?
No I emailed Wolverine and as usual with their unmatched customer service they took care if it immediately. It was mentioned this has never been seen with the operating rod before. Parts were sent out a few hours after I contacted Wolverine.
Im sure they will discuss this with RA!
No I emailed Wolverine and as usual with their unmatched customer service they took care if it immediately. It was mentioned this has never been seen with the operating rod before. Parts were sent out a few hours after I contacted Wolverine.
Im sure they will discuss this with RA!
Awesome. Wolverine has always been good to me.
J
So, did Wolverine send out another piston to you immediately or are they getting the parts shipped from RA? Wolverine has always been awsome, but would they have all the parts for repair for major internal stuff like that?
I finally got my new XCR-M and I got to cleaning it as I do when I get any new rifle so I know that everything is lubed up and good to go but it was dirty it took me 1hr just to get all the internals clean. Has anyone else received there XCR-M in this condition and yes I undstand that they test fire the gun and I would think that robarms would clean before shipping .
Any suggestions for a scope for the XCR-m I am going to use it as fare as 300 yards or possibly further provided it can perform at 300 pulse.Does anyone have some suggestions or like share what works great on there rifle .Keep in mind I have a max of 1000 I can hide from the wife .She still hasn't found out about the new XCR but it's easier to ask forgiveness than permission And that's why I just orders a new daneil defence AR .
You would think they would clean it. When you pick up a new car, they usually wash it and gas it for you. I guess the benefit to this is the evidence of the fact they tested it. Depends on how you look at it. Unless that's the one they did all their stress tests with. Lol! You'll have to give us a range report.
