- Location
- Richmond, BC
See post 4062, lol!
http://2.bp.########.com/-DPuTt-Mz0YI/VlVFSizuCjI/AAAAAAAAZik/QNyXTzHbu30/s1600/Screenshot_2015-11-24-06-42-43.jpg
It gets a bit warm up front sometimes, haha!
AR-15's
- Thread starter Nats
- Start date
See post 4062, lol!
http://2.bp.########.com/-DPuTt-Mz0YI/VlVFSizuCjI/AAAAAAAAZik/QNyXTzHbu30/s1600/Screenshot_2015-11-24-06-42-43.jpg
It gets a bit warm up front sometimes, haha!
- Location
- Richmond, BC
I should probably have it checked out, haha!
That's some nice photography.
incorrigible
CGN frequent flyer
- Location
- stubble jumper
a little subtle bling to replace with a skull mag release button 
Last edited:
a little subtle bling to replace the mag release button
How do you like the Troy handguard? I'm just waiting on a low pro gas block to install mine.
Changed part of my RIS II today. Now I can sell my black RIS II if anyone is interested.
It all went smoothly except for pinning the gas block back to the barrel. That was a bigger. I think it's ok.
Here's where that pin ended up. It was just about the same before. So we should be good. But if this isn't any good, I'll get a new pin. But it wouldn't go in any further. Pin was probably mushroomed out a bit. It's in there very firmly. Gas block is night and tight.
It all went smoothly except for pinning the gas block back to the barrel. That was a bigger. I think it's ok.
Here's where that pin ended up. It was just about the same before. So we should be good. But if this isn't any good, I'll get a new pin. But it wouldn't go in any further. Pin was probably mushroomed out a bit. It's in there very firmly. Gas block is night and tight.
OldFrankHog
CGN frequent flyer
- Location
- Gatineau QC
Looks good. I like the Alpha rail it's light.
Nice selection. The ARAK uppers are shweet
!0.5" Vltor upper on T15BDX lower with Hiperfire24C trigger sitting next to the Arak21 upper chambered that day in 7.62x39
