I put the SGA's on my 590 mag fed. Could be willing to part with the take off's. PM me if interested.
Mossberg 500/590 Info
- Thread starter Dsiwy
- Start date
I put the SGA's on my 590 mag fed. Could be willing to part with the take off's. PM me if interested.
CanadianGunMan
New member
- Location
- Toronto, ON
Looking to replace my factory 500 stock with a Magpul variant. Looking at it I'm not sure which size bolt/washer it is, as I have to buy a socket wrench/torque wrench for the job. Could anyone recommend me what they used to get the bolt off? Thanks
Greenhorse six
CGN Ultra frequent flyer
Some are slotted for a flat screwdriver as well as a socket wrench.
The standard one is a grade 8 bolt, 5/16" x 18 TPI (threads per inch) 5 1/2 inches long .
Hope that helps .
okcorral1881
CGN Ultra frequent flyer
- Location
- East of Toronto
cerebral_bore
CGN frequent flyer
Anyone have a spare black synthetic OEM Mossberg 590 buttstock?
As the poster above (Channel 0) mentioned the only replacement available from CGN vendors appears to be a Magpul SGA at $150-$175...
A few CGN vendors have the Hogue 590 overmold buttstock and foreend set, but all sold out.
eBay - no luck.
As the poster above (Channel 0) mentioned the only replacement available from CGN vendors appears to be a Magpul SGA at $150-$175...
A few CGN vendors have the Hogue 590 overmold buttstock and foreend set, but all sold out.
eBay - no luck.
Last edited:
cerebral_bore
CGN frequent flyer
PM sent.
Currently have a Mossberg 590S with the synthetic stock. The butt is a little long for the wife to use correctly and was looking for a decent adjustable butt stock as a replacement. I've looked around a lot of sites and see mention of a lot of replacements that are for compatible with 500's, 590's, 590A1's and even 590M's but no mention of the 590S. Would it be reasonable to assume that a stock compatible with the the versions mentioned, would work with a 590S?
Greenhorse six
CGN Ultra frequent flyer
Thats a reasonable assumption, the only one that would be different, for a Mossberg, would be one using the flex system.
Shoot me a message, I don't mind clearing out my storage
I'll bump the thread by adding something I didn't know and the guys here on CGN assisted. Parkerized finishes (590A1), should be oiled or greased like seasoning a cast iron pan. The Parkerizing has a sandy finish and is crystalyn in its structure. Theses crystals hold oil/grease in their mediums and it is this that gives corrosion protection.
I cut 3/4" off the butt of my 590S and the LOP is perfect now.
Hi,Just picked up a used Mossberg590 with 20" barrel.Numbers on the barrel dont match the receiver.Maybe Im hoping for too much but it might be a 590A1 heavy barrel on it.Is there a way to know for sure?Its a 20" with bayo lug and heatshield,bead sight.Any help?Dave
