T97NSR; Range Trip, 2nd Time Updated With New Pics!

Travis Bickle

CGN Ultra frequent flyer
Rating - 100%
179   0   1
I haven't see too many threads on these rifles with regards to accuracy/ability.
Especially with regards to trialing different brands of the more common types of .223 Rem.

I finally bit the bullet and picked up a T97 second hand from a close friend. The rifle is stock condition except for the front sight post which my buddy did an excellent job of filing down into a much thinner post.



I'm told it's a 1:7 twist rate barrel, which the results seemed to lean towards as it shot the 55gr and 62gr with more or less equal results.

I zeroed the rifle at 50 meters with the 62gr US Green Tip for a 6 o'clock hold to hit center of the target about 3" high. Before trying the different brands.

Ammo brands used were:

5.56mm Norinco 55gr FMJ
.223 Rem MFS 55gr FMJ
5.56mm 62gr US Green Tip Surplus FMJ
.223 Rem 62gr Commercial Federal Soft Point Hunting ammunition.

The trials I did were at free Canam. Targets that came with my crate of 5.56 Norinco ammo :rockOn:
Each target was shot at just over 50 meters from the prone with iron sights set at the "1" aperture using 10 rounds of each of the 4 brands of ammunition, the barrel was allowed to cool for at least 5 minutes between 10 round groups.

Here is the Norinco 5.56mm 55gr FMJ:


Then Federal .223 Rem 62gr Soft Point Hunting Ammo:


Good Ol' El Cheapo MFS .223 Rem 55gr FMJ:


Then the 5.56mm 62gr Green Tips FMJ, U.S. Surplus:


I was pretty surprised. The Commercial Federal 62gr shot the worst of the bunch! That is $18 after tax for 20 rounds, name brand ammunition.
The Norinco didn't do too bad in comparison but the obvious winner is the standard U.S. 62gr FMJ followed by the MFS 55gr FMJ.

I was pretty impressed with the relative accuracy for a bullpup, semi auto, short stroke gas piston operated, combat rifle design. Not too bad at all.

I pushed out to 130 meters with my target. I didn't have a very good sight picture, just a black square I made with target patches.
It was just a dot at 130 meters, very hard to get consistent sight picture
.

This first group is with the last 10 rounds of the 62gr FMJ U.S. Green Tip Surplus at 130 meters from the prone with the iron sights (zeroed at 50 meters on aperture "1"):


Then I patched the target and shot another 10 rounds groups exactly the same target and distance with 55gr MFS FMJ:


Not bad considering the distance, the average at best ammunition and the iron sights of the rifle.

I think it is capable of better at distance of 130 meters +, the next time I take it out I will try again with 55gr MFS and 62gr MFS with a nice big upside down triangle to get some consistency for the iron sights.

That being said I really don't find the sights on it all that bad at all. I find to get the best picture with them, you have to get your face right up close to the handle, nose almost touching the rear of the carry handle.

It seems to like the FMJ more than anything, I only experienced a couple stoppages, they were failures to feed with the soft point hunting ammunition. Caused by the short flat projectile tip hitting the bottom of the feed ramp instead of hitting the angle and feeding it up and into the chamber, basically it never even left the magazine with the bolt pressing it into the bottom of the feed ramp and the action frozen in that position.

I put at least 300-400 rounds through it that day with only the 2 stoppages attributed to the soft point ammunition. That was with one single initial oiling and then shot it until I was done. It's a very reliable rifle. Simple, rugged, reliable, easy to handle due to the bullpup design, I shot it quite a bit from the standing and the sitting position as well and it was extremely easy to hold and keep solid on target. I could do it all day with little effort.

I was a bit dissapointed at the 130 meter groups but then again, I am attributing it to the bad target being used. Will try again with large upside down triangles. I'm sure the rifle will do better than that. With the groups being what they were at 50 meters, I'm very anxious to get out again and use better targets so I can actually get a consistent sight picture past 100 meters.

Long story short, I love this rifle. No real complaints, the mag release could be a bit larger, I can live with the mag release and the safety being where they are, I'm not a tacticool, zombie slaying ninja or whatever, it works fine. The mag release being bigger would only be better so as to not chew the s**t out of your finger tip after so many reloads. The trigger is long and squishy typical of the bullpup design, though it's not gritty at all, I didn't find it that bad at all, it broke consistently though it's hard to tell when it's going to break. That being said it also eliminates any flinch factor so I found it very easy to shoot.

Anyone else used the irons past 100 meters and gotten different results with commercial/non handloaded ammunition?
 
Last edited:
I'd say you should be pleased with your 130m group, more so then your 50m groups...that's not bad for the target you had and distance. The 50m 5" groups is kind of sad lol
 
I'm hiting a 10"x10" plate at 100 yards every shot with the gun rested on the shooters table. Standing prone I can get it about 6 out of ten times.....I'm kinda crapy at prone, BUT I can shoot the T97 better prone than my AR. The short little 97 isn't front heavy. My 50 yard groups are the same as Travis got. I REALLY like this rifle. No ftfire or ftfeed or fteject at all.
 
I'd say you should be pleased with your 130m group, more so then your 50m groups...that's not bad for the target you had and distance. The 50m 5" groups is kind of sad lol

Do you have tips to shoot better? I have similar groupings to OP and at that distance, the target becomes a dot and its really hard to pin point the exact same target hit after hit.
 
Do you have tips to shoot better? I have similar groupings to OP and at that distance, the target becomes a dot and its really hard to pin point the exact same target hit after hit.

Practice....zero using a 6'oclock hold....think pumpkin on a fence post for your sight picture, front sight should be your focal point, not the target. Learn how to use a sling to steady the rifle in different shooting positions. Shoot slow, pay attention to your breathing, and trigger pull should be smooth not jerky. Shoot lots until you get it down.
 
Practice....zero using a 6'oclock hold....think pumpkin on a fence post for your sight picture, front sight should be your focal point, not the target. Learn how to use a sling to steady the rifle in different shooting positions. Shoot slow, pay attention to your breathing, and trigger pull should be smooth not jerky. Shoot lots until you get it down.

That's the method I use for sighting/zeroing.

I can put 10 rounds through a 2" circle with my M14 at 50 meters so I don't think it's my "skill" level.
Most likely getting used to the looooong squishy trigger pull lol This was the first time I really shot the rifle prior to putting like 5 rounds through a friends.

I usually use upside down triangles especially for distance.
 
Travis, are you planning to load for this rifle. I have good luck with 8208xbr for 223.

No Sir. I don't reload yet, no time or space.
Maybe down the road a ways I'll set up for it.

Not sure if it would be worth reloading for it honestly, it's a semi auto combat rifle design, made to be minute of man at 300 meters accurate. I don't think you could squeeze all that much more out of it without optics etc but at that point I'd just buy a $250 Stevens 200 and shoot sub MOA all day long for a fraction of the price lol It just wouldn't Chic-Com Tacticool! :D

Will try at distance with better target image, I know I can do better than that with the right target.

Do you reload for the T97? What results are you getting out of curiosity?
 
No Sir. I don't reload yet, no time or space.
Maybe down the road a ways I'll set up for it.

Not sure if it would be worth reloading for it honestly, it's a semi auto combat rifle design, made to be minute of man at 300 meters accurate. I don't think you could squeeze all that much more out of it without optics etc but at that point I'd just buy a $250 Stevens 200 and shoot sub MOA all day long for a fraction of the price lol It just wouldn't Chic-Com Tacticool! :D

Will try at distance with better target image, I know I can do better than that with the right target.

Do you reload for the T97? What results are you getting out of curiosity?
I don't reload for the t97. I do reload for my AR's and my savage axis coyote gun. 8208xbr is my favorite powder for 223. I want a t97 but I haven't pulled the trigger yet. Its a really stable powder that burns clean and doesn't seem bothered by temperature.
 
With the FTU installed and a 3-12x44mm mil dot scope. I achieved a .5" group at 100yds with Federal Premium ammo (nosler ballistic 55gr P223F) and 1" groups with federal premium (sierra gameking BTHP 55gr P223E) All the FMJ I tried (norinco, MFS, American eagle) shot pretty horribly, about 2" to 4" with no consistency. With one exception, Winchester 55gr FMJ (white box from wal-mart @ 9.97+tx) It gave me a 1.25" group at 100yds. I have not ventured into reloads yet. If I find anything more on which ammo shoots the best out of MY T97NSR I will let you guys know.
 
Thanks for the report!
Those are 1" squares on the targets?
You report shooting 2" groups at the same range with your M14.
So, the T97 is running 4" groups at that distance - 8 moa. That would seem to leave a bit to be desired.
kouik reports much better accuracy with a scope, so maybe it is just the irons.
 
I was a bit dissapointed at the 130 meter groups but then again, I am attributing it to the bad target being used.
I think you're right—although the groups are not what I'd call disappointing at that distance! Looking at the targets, the side-to-side (windage) group size is significantly smaller than the top-to-bottom size (elevation), and is probably more indicative of the rifle's accuracy potential. I'm guessing that the small aiming point may have contributed to slight elevation aiming errors. However, 130m is a long way to shoot with iron sights, especially with a new rifle. I'm guessing that an easier-to-see target will give you smaller group sizes.
 
Thanks for the report!
Those are 1" squares on the targets?
You report shooting 2" groups at the same range with your M14.
So, the T97 is running 4" groups at that distance - 8 moa. That would seem to leave a bit to be desired.
kouik reports much better accuracy with a scope, so maybe it is just the irons.

Might be the irons, but I usually shoot only iron sights. None of my rifles are scoped.

They are 1" patches.

I think the grey squares on the light grey silhouette may have been a bad target, it's all I had out there that day to use for 130 meter targets.

I was pretty unimpressed with the performance at 130 meters, be it my shooting (doubtful) or the bad target used.

Will try again soon with much better target and post results.
 
I think you're right—although the groups are not what I'd call disappointing at that distance! Looking at the targets, the side-to-side (windage) group size is significantly smaller than the top-to-bottom size (elevation), and is probably more indicative of the rifle's accuracy potential. I'm guessing that the small aiming point may have contributed to slight elevation aiming errors. However, 130m is a long way to shoot with iron sights, especially with a new rifle. I'm guessing that an easier-to-see target will give you smaller group sizes.

Ack, that's what I'm hoping too.
I hope so, I like the rifle a lot so I'm hoping it can do a bit better.
 
Might be the irons, but I usually shoot only iron sights. None of my rifles are scoped.

They are 1" patches.

I think the grey squares on the light grey silhouette may have been a bad target, it's all I had out there that day to use for 130 meter targets.

I was pretty unimpressed with the performance at 130 meters, be it my shooting (doubtful) or the bad target used.

Will try again soon with much better target and post results.

Before I installed the FTU I could not seem to get any consistency in my shot pattern. The irons that comes on the T97 are not very good. The peeps are too small and the front sight is really hard to fine tune. not to mention that the front post covers about 8 inches of a target at 100yds. best group I achieved with the factory iron...6"...more or less. My advice would be to buy the FTU and a set of high quality AR-15 sights, like LMTs or TROYs. I know its a lot of money but... AND if your middle name is McGyver, you could drill the rear aperture slightly bigger and file your front post until its about 2mm to 1.5mm wide. Just my 2 cents.
 
Back
Top Bottom