Brown sugar in a pair of 2x4s with a 1/2in hole drilled between them evenly, in a standard vice will hold a barrel for a 50ftlbs torque... Works great for muzzle device crush washers too. Never had a mark left after on any barrel finish.
Crusader Arms Crypto
- Thread starter MilsurpLover
- Start date
Anodizing. Highly desirable in the land of the free ARs... On a serious note - go ahead and check the thread, lot of interesting information about the process - https://www.ar15.com/forums/ar-15/Faded-to-purple-anodizing-/118-777113/
You'll see it on older Colts or other ARs I personally like it
Yes, they should all go to irunguns for a course. They are the best. I had it all with different magazines, 4 rounds, then 6 rounds, even a 10 round screw up, some would not even fit.
I had to dremel out the ejection port cover hole on the brass deflector. My ejection port cover sat at an angle and wouldn’t latch properly
BlueJeanBandit
Member
- Location
- British Columbia
Mine wouldn’t latch either, I just put a Strike Industries(Yes I Know) cover and fixed it.
Also the hole for my rear takedown pin spring and detent were drilled WAY out of spec…had to modify a takedown pin so it could *snap* properly.
Other than that the rifle is very tight and functions perfectly
Magazine comments...
Go to a single stack 5 round. This would allow much heavier feed lips and magazine walls.
Go to a metal magazine.
Either would be sturdier than the current magazine.
Offer 5/5 magazines with an optional connector OR an extended base (like a lot of 10 rd pistol magazines. Service Rifle competitors would appreciate this. The rifles could be monopodded.
5 round magazines must hold at least 5 1/2 rounds for ease of insertion when the bolt is closed.
Go to a single stack 5 round. This would allow much heavier feed lips and magazine walls.
Go to a metal magazine.
Either would be sturdier than the current magazine.
Offer 5/5 magazines with an optional connector OR an extended base (like a lot of 10 rd pistol magazines. Service Rifle competitors would appreciate this. The rifles could be monopodded.
5 round magazines must hold at least 5 1/2 rounds for ease of insertion when the bolt is closed.
PinaKaleada
CGN Regular
- Location
- South of most
Curious what would the legal procedures one would take if all of a sudden RCMP deemed this prohibited? Do you surrender it to the RCMP?
